Main menu

Pages

How to make a handheld tracking device

How to make a handheld tracking device to search for treasures and burials in the ground, Creating a handheld tracking device for searching treasures and burials involves assembling components that can detect location and potentially log data for later analysis. Below is a guide on how to build a simple GPS-based tracking device using readily available components.


How to make a handheld tracking device



How to make a metal detector from a magnet at home

If you want to become a treasure hunter, the first thing you need to get the metal detector. Although at first it is quite possible to do...


Materials Needed

Microcontroller:

ESP32 or Arduino board (e.g., ESP WROOM, TinyDuino).

GPS Module:

A GPS module such as the u-blox Neo-6M or ATGM336H for location tracking.

Power Supply:

A rechargeable battery (e.g., lithium polymer battery) to power the device.

Display (optional):

A small display (e.g., OLED or LCD) to show location data.

Storage:

MicroSD card module for logging data (optional).

Casing:

A portable enclosure to hold all components securely.

Connecting Wires:

Jumper wires for connections between components.

Software Tools:

Arduino IDE or similar software for programming the microcontroller.


How to make a metal detector in their home

How to make a metal detector How to make a metal detector with his hands now metal detectors are not cheap, but you can always buy a metal d...


Step by Step Instructions


1. Assemble the Components

Connect the GPS module to the microcontroller using the appropriate pins (TX, RX, power, and ground). For example, connect the GPS's TX pin to the RX pin on the ESP32.

If using a display, connect it according to its specifications.

If logging data, connect the microSD card module to the microcontroller.


Scheme for metal detector How to make a homemade metal detector

With the onset of spring more and more often on the banks of rivers you can meet people with metal detectors. Most of them are engaged in &...


2. Write the Code

Use Arduino IDE to write a program that initializes the GPS module and reads location data (latitude and longitude).

Optionally, log this data to a microSD card or display it on an LCD screen.


How to make a simple metal detector

In this project we are going to design a simple metal detector circuit. Today we know a large number of ways to make a metal detector at ho...


3. Powering Up

Connect your battery to power the microcontroller and GPS module.

Ensure all connections are secure.


4. Testing

Power on your device and allow it to acquire GPS signals (this may take a few minutes).


Check if the device outputs correct latitude and longitude readings in the serial monitor of your IDE.


How to make a DIY metal detector

This metal detector has won the fame of a simple and not expensive device , a small number of available parts, with proper assembly and corr...


5. Data Logging (Optional)

If you want to log data, modify your code to write location data to a microSD card at regular intervals.


6. Enclosure

Place all components inside a portable enclosure for ease of use during treasure hunting or burial searches.


7. Field Use

Take your device outdoors in an area where you suspect treasures or burials may be located. Monitor the GPS readings and log them for later analysis.


Simple metal detector on two chips NE 555

Simple metal detector on two chips NE 555, How to make a simple metal detector. Can you find the gold hidden underground with this metal de...


Signal Interference, Be aware that dense foliage or large structures can interfere with GPS signals. Ensure your battery has sufficient charge for extended use. You may need to calibrate your device based on environmental conditions. By following these steps, you can create a functional handheld tracking device that can assist in locating treasures or potential burial sites using GPS technology.

table of contents title